The One Cleaning Solution to NEVER Use On Your Landscape Fountains
The One Cleaning Solution to NEVER Use On Your Landscape Fountains It is important to carefully maintain water fountains for them to work optimally. A typical concern with fountains is that they tend to accumulate dirt and debris, so it is vital that you keep it free from this. Another factor is that water that is subjected to sunlight is prone to growing algae. Stir hydrogen peroxide, sea salt, or vinegar into the water to avoid this particular issue. There are those who like to use bleach, but that is hazardous to any animals that might drink or bathe in the water - so should therefore be avoided.Every three-four months, garden fountains should go through a serious cleaning. Prior to cleaning, all of the water must be eliminated. Next use mild soap and a soft sponge to clean the innner part of the reservoir. A helpful tip is to use a toothbrush if there are little hard-to-reach spots. Be sure to thoroughly rinse the interior of the fountain to make sure all the soap is gone.
It is highly suggested taking the pump apart to better clean the inside and remove any plankton or calcium. Soaking it in vinegar for a bit will make it easier to wash. If you want to remove build-up in your fountain, use rain water or mineral water rather than tap water, as these don’t contain any ingredients that might stick to the inside of the pump.
Finally, be sure to have a quick look at your fountain daily and add water if you see that the level is low. Allowing the water to reach below the pump’s intake level, can cause serious damage and even make the pump burn out - an undesired outcome!